Reference number
ISO 14679:1997
International Standard
ISO 14679:1997
Adhesives — Measurement of adhesion characteristics by a three-point bending method
Edition 1
1997-09
Preview
ISO 14679:1997
25226
недоступно на русском языке
Опубликовано (Версия 1, 1997)
Последний раз этот публикация был пересмотрен в  2023. Поэтому данная версия остается актуальной.

ISO 14679:1997

ISO 14679:1997
25226
Язык
Формат
CHF 63
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This International Standard specifies a test method to determine the ability of a cured adhesive (if necessary with a primer) to adhere to a substrate with a certain surface finish, or which has been subjected to a specific surface preparation, using the "three-point bending method".

This standard is only applicable to quality assurance and only to substrates which are rigid or resistant enough to bending, such as steel or aluminium alloys. For other substrates, the thickness is adjusted to the modulus of elasticity or a suitable stiffener is used.

The adhesive is allowed to cure without the application of pressure in order to obtain the thickness needed to provide sufficient rigidity, otherwise a bonded reinforcing piece of the same material and the same thickness as the substrate is substituted for the block of adhesive.

This test method is not suitable for film adhesives.

Общая информация

  •  : Опубликовано
     : 1997-09
    : Подтверждение действия международного стандарта [90.93]
  •  : 1
  • ISO/TC 61/SC 11
    83.180 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ