Reference number
ISO 11119-3:2020
International Standard
ISO 11119-3:2020
Gas cylinders — Design, construction and testing of refillable composite gas cylinders and tubes — Part 3: Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 l with non-load-sharing metallic or non-metallic liners or without liners
Edition 3
2020-11
Read sample
ISO 11119-3:2020
75817
Published (Edition 3, 2020)
This standard has 1 amendment.

ISO 11119-3:2020

ISO 11119-3:2020
75817
Language
Format
CHF 173
Convert Swiss francs (CHF) to your currency

Abstract

This document specifies minimum requirements for the material, design, construction and workmanship, manufacturing processes, examination and testing at time of manufacture for:

— type 4 composite fully wrapped cylinders or tubes with a non-load sharing liner and composite reinforcement on both the cylindrical portion and the dome ends;

— type 5 fully wrapped cylinders or tubes without liners and with a test pressure of less than 60 bar and composite reinforcement on both the cylindrical portion and the dome ends;

— water capacities up to 450 l;

— for the storage and conveyance of compressed or liquefied gases;

— cylinders and tubes with composite reinforcement of carbon fibre, aramid fibre or glass fibre (or a mixture thereof) within a matrix;

— a minimum design life of 15 years.

Cylinders and tubes manufactured and tested according to this document are not intended to contain toxic, oxidizing or corrosive gases.

This document does not address the design, fitting and performance of removable protective sleeves.

NOTE 1 References to cylinders in this document include composite tubes if appropriate.

NOTE 2 ISO 11439 applies to cylinders intended for use as fuel containers on natural gas vehicles and ISO 11623 covers periodic inspection and re-testing of composite cylinders.

General information

  •  : Published
     : 2020-11
    : International Standard published [60.60]
  •  : 3
     : 48
  • ISO/TC 58/SC 3
    23.020.35 
  • RSS updates

 Amendments

Amendments are issued when it is found that new material may need to be added to an existing standardization document. They may also include editorial or technical corrections to be applied to the existing document.

Amendment 1

Edition 2023

ISO 11119-3:2020/Amd 1:2023
85413
Language
Format
CHF 18
Convert Swiss francs (CHF) to your currency

Got a question?

Check out our Help and Support