Reference number
ISO 6507-1:2023
© ISO 2024
International Standard
ISO 6507-1:2023
Metallic materials — Vickers hardness test — Part 1: Test method
Edition 5
2023-10
Preview
недоступно на русском языке
Опубликовано (Версия 5, 2023)

ISO 6507-1:2023

Язык
Формат
CHF 151
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This document specifies the Vickers hardness test method for the three different ranges of test force for metallic materials, including hard metals and other cemented carbides (see Table 1), metallic coatings and other inorganic coatings.

The Vickers hardness test is specified in this document for lengths of indentation diagonals between 0,020 mm and 1,400 mm. Using this method to determine Vickers hardness from smaller indentations is outside the scope of this document as results would suffer from large uncertainties due to the limitations of optical measurement and imperfections in tip geometry.

The Vickers hardness specified in this document is also applicable for metallic and other inorganic coatings including electrodeposited coatings, autocatalytic coatings, sprayed coatings and anodic coatings on aluminium.

This document is applicable to measurements normal to the coated surface and to measurements on cross-sections, provided that the characteristics of the coating (smoothness, thickness, etc.) permit accurate readings of the diagonal of the indentation.

This document is not applicable for coatings with thickness less than 0,030 mm when testing normal to the coating surface. This standard is not applicable for coatings with thickness less than 0,100 mm when testing a cross-section of the coating. ISO 14577-1 can be used for the determination of hardness from smaller indentations.”

A periodic verification method is specified for routine checking of the testing machine in service by the user.

For specific materials and/or products, relevant International Standards exist.

Общая информация

  • Текущий статус
     : Опубликовано
    Дата публикации
     : 2023-10
    Этап
    : Опубликование международного стандарта [60.60]
  • Версия
     : 5
  • Технический комитет :
    ISO/TC 164/SC 3
    ICS :
    77.040.10 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

  2. Интернет-магазин
  3. Каталог стандартов
  4. ТК
  5. ISO/TC 164/SC 3
  6. ISO 6507-1:2023