ISO 9085:2002

No disponible en español

Publicado (Edición 1, 2002)

Esta publicación se revisó y confirmó por última vez en 2023. Por lo tanto, esta versión es la actual.

CHF 194

Convertir Franco suizo (CHF) a tu moneda

Resumen

The formulae specified in this International Standard are intended to establish a uniformly acceptable method for

calculating the pitting resistance and bending strength capacity of industrial gears with spur or helical teeth.

The rating formulae in this International Standard are not applicable to other types of gear tooth deterioration such

as plastic yielding, micropitting, scuffing, case crushing, welding and wear, and are not applicable under vibratory

conditions where there may be an unpredictable profile breakdown. The bending strength formulae are applicable

to fractures at the tooth fillet, but are not applicable to fractures on the tooth working profile surfaces, failure of the

gear rim, or failures of the gear blank through web and hub. This International Standard does not apply to teeth

finished by forging or sintering. It is not applicable to gears which have a poor contact pattern.

This International Standard provides a method by which different gear designs can be compared. It is not intended

to assure the performance of assembled drive gear systems. Neither is it intended for use by the general

engineering public. Instead, it is intended for use by the experienced gear designer who is capable of selecting

reasonable values for the factors in these formulae based on knowledge of similar designs and awareness of the

effects of the items discussed.

CAUTION — The user is cautioned that the calculated results of this International Standard should be

confirmed by experience.